Information on the
TaitNet Ethernet SIF Templates.
This information updated 16
November 2006.
Introduction:
These templates are supplied with suggested defaults parameters
for the TB8100 Base Station when used with the TaitNet Ethernet SIF and
Tait MPT Trunking Infrastructure.
These templates are referenced to, and fully explained in TN-745-AN.
Release date - 22 May 2006 available from the Tait Technical Support Website.
Changes:
The change is to prevent
the second reciter in a dual base station reporting a minor alarm for
low battery and AC alarms as no PMU is connected. The high PA
temperature minor alarm has been transferred from a custom input to the
task manager. The default IP address of reciter 2 has also been changed
to 192.168.0.3, reciter 1 default is 192.168.0.2. These templates will
be added to the next release of the TB8100 product CD.
File name information:
Single_Trunking_Reciter.t8t - For use with a base station
utilising a single reciter.
Dual_Trunking_Reciter_R1.t8t - For use with Base Station utilising 2
reciters. Use this for reciter '1'. Reciter 1 is on the left when
viewed from the front of the base station.
Dual_Trunking_Reciter_R2.t8t - For use with a dual reciter version Base
Station. Use this for reciter '2'. Reciter 2 is on the right when
viewed from the front of the base station.
File Locations:
Copy the templates
to
C:\Program
Files\Tait Programming Applications\TB8100 Service Kit\Templates
if you have installed the Service Kit in the default location.
To use these templates, select File > New in the TB8100 Service Kit
and select the template you want to use.
Compatibility:
These templates were set up in Service Kit V3.00 and will work in later
versions. The Ethernet SIF is supported by reciter firmware V3.00
and later.
Misc Information:
The default IP address for reciter 1 is 192.168.0.2. Reciter 2 default
IP address is 192.168.0.3.
Any further questions contact Tait Technical Support - support@taitworld.com